The ENMAT Pulse Acquisition module designed for use with any device that provides a pulsed signal, such as energy, gas, water and heating meters.
150 Amp Split Core Current Transformer Clamps with high accuracy (<1%) over the current range with phase shift of less than 2 degrees at 50% of rated current.
The ENMAT LED Light sensor picks up the light output pulses from single phase or 3-phase energy meters and converts this into an electrical pulse.
For each installation point, you need the right saddle. The exact outer diameter is important to select the right saddle. For suitable hot tap saddles, ask the ENMAT team.
The hot tap drill is the universal tool to install your insertion flow meter in any compressed air system. In only 30 minutes you can drill a hole and install your flow meter. Using a hot tap saddle and a hot tap drill, you can create a new installation point without depressurizing your installation